Chapter 2. Film Features; Films To Be Used; Band A Calculation; Chapter 3. Machine Usage Conditions - Minipack-Torre Media Matic Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 2. Film features

2.1. Films to be used

The machine can work with all heat-shrink and non-heat-shrink films, from 15 to 50
microns in thickness, of a technical and food type.
To guarantee the best results, use the films marketed by us.
The special features of our films assure their outstanding reliability, with regard both to
compliance with laws in force and to excellent machine performance.
A = 600mm MAX D = 350mm MAX
Consult the data and safety sheets of the films in use and observe the
corresponding instructions!

2.2. Band A calculation

Band A = b + c + 100mm
By band "A" we mean the width that the film must have to package the product.

Chapter 3. Machine usage conditions

3.1. Max. pack sizes

a = 550mm b = 380mm
Note: max. dimensions shown on above scheme are referring to the max. dimension of the
single package. Refer to chapter 2.2. to get max. dimension of package (b x c); the
addition of (b + c) is equal to film roll width 100 mm.

3.2. Items that may be packaged

These machines are capable of packing a wide range of completely different products. They are used successfully in the
following sectors: food, marketing, graphics and mailing, large distribution, industry, fabrics.

3.3. Items which must not be packed

The products listed below must absolutely not be wrapped to avoid permanent damage to the machine and serious
injuries to the operator:

Wet and unstable products

Liquids of any kind and density in fragile containers

Flammable and explosive materials

Pressurised gas cylinder of any kind

Loose and volatile powders

Any materials and products not listed but which might harm operator and damage the machine.

Chapter 4. Safety standards

4.1. Warnings

It is extremely important to read this entire chapter as it contains important information regarding risks that personnel are
subject to in the event of incorrect use of the machine. These basic standards must be observed as well as specific
standards applicable in the country of installation.

The machine must be installed by trained and authorised technicians.

This machine is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack experience and knowledge, unless they have been given supervision or instruction concerning
use of the machine by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the machine.

Never use the machine for purposes other than as specified in the sales contract.

Never allow unauthorised personnel to perform repairs or other operations on the machinery.

The operator must be familiar with all warnings related to the tasks in hand and always be informed by the head of
the site regarding risks.
d = 77mm
c = 100mm
18
EN
EN
EN