Environmental Conditions; Electrical Connections - Minipack-Torre Media Matic Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 5. Machine installation
Position the kit components of the roller unit on the machine.
The kit consists of:
1 product evacuation roller unit (r1) to be hooked to the tunnel conveyor belt outfeed,

2 safety rollers (r2) to be placed in the tunnel infeed area,

2 safety rollers (r3) to be placed in the tunnel outfeed area.


5.2. Environmental conditions

Place the machine level on the floor in a suitable environment free from humidity, gases, explosives, combustible

materials. The machine may only be installed on smooth, flat non-inflammable surfaces
Leave a minimal space of 0,5m around the machine so that not to obstruct air outlets

Once the correct height is abtained, block the machine by means of the wheel brakes.

Working environmental conditions:
Temperature from + 5°C to + 40°C

Relative humidity from 30% to 90%, without condensation

The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator's safety and health.
MACHINE SAFETY FACTOR = IP20
THE AIRBORNE NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB(A)

5.3. Electrical connections

Voltage (V): see data on plate
Frequency (Hz): see data on plate
Maximum absorbed power (W): see data on plate
Maximum absorbed current (A): see data on plate
Note: When contacting the Manufacturer, always indicate the model and the serial number
specified on the plate on the rear part of the machine.
OBSERVE HEALTH AND SAFETY REGULATIONS!
If the machine is not equipped with the power supply plug, use a plug that is suitable for the
voltage and amperage values described by the rating plate and that can comply with the rules in
force in the installation country.
GROUNDING OF THE UNIT IS OBLIGATORY!
Before making electrical connections, make sure the mains voltage matches the one on the
plate on machine rear and that the ground contact complies with the safety rules in force.
In case of doubts about the mains voltage, contact the local power supply company.
Insert the plug on the cable from machine electrical cabinet in a mains power supply socket that
can be reached easily by the operator.
21
EN