Manual And Automatic Cycle; Alarm Messages; Film Reel Insertion - Minipack-Torre Media Matic Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 6. Machine adjustment and setting up

6.1.2. Manual and automatic cycle

The machine can be operated with a manual as well as with an automatic cycles.
Manual cycle: To carry out only one operating cycle rotate the selector (S2) to the "MAN." position and press the
start button (S1).
Automatic cycle: To operate the automatic cycle rotate the selector (S2) to the "AUT." position and press the start
button (S1).
If the machine is set to operate in automatic mode, then pressing the start button will start the
machine by carrying out the cycles sequentially and only divided by the set pause times.
The machine is equipped with an EMERGENCY PUSHBUTTON (S0) which blocks it immediately when

pressed, bringing the sealing frame into start position.
The machine has also an automatic safety system on the welding frame which intervenes in case the

lowering of the frame is hindered, bringing the frame back in the start position.

6.1.3. Alarm messages

The electronic board detects series of alarms that are indicated on the display (D1) by the following messages:
E 1 Machine has been switched on when sealing frame was lowered.
Lift sealing frame up.
E 2 Machine has been switched on when (S) button was pressed. Release button. In case the error signalling still
persists, check the correct functioning of the button.
E 4 Temperature is higher than 450°C or feeler has been cut off.
Switch the machine on to reset.
E 6 The limit switch to cut out security is broken (it is always closed). Check the correct functioning of the limit switch to
cut out security, then switch the machine off and on again.
E 7 Tunnel blocked for thermic intervention of fan motor or inverter relay.
Contact the assistance service.
- - Sealing frame not in proper position when switching machine on. Press emergency pushbutton to lift hood. Once it
has been lifted,signalling will disappear.

6.2. Film reel insertion

Insert the roll of film on the roller (1) and block it

through the centering cones (2).
Position the roller on the film reel support (3).

Run through the micropunches (4).

Run the film lower layer under the packaging plate (5).

Run the film upper layer over the packaging plate (5).

24
EN