Machine Operating Modes; Automatic Mode; Manual Mode - Minipack-Torre Pratika 56 Anweisungen Zur Bedienung Und Wartung

Chapter 5. Machine adjustment and setting up

5.2.1. Machine operating modes

The machine can be operated in 2 modes: AUTOMATIC, MANUAL.

5.2.1.1. AUTOMATIC mode

This is the completely automatic machine operating condition.
The above screen illustrates the operating condition in Automatic STOP mode.
The above screen illustrates the operating condition in Automatic START mode.

5.2.1.2. MANUAL mode

This condition is necessary when carrying out the set-up procedures and when inserting or changing the film reel.
In this phase, you can open the guards by turning the selector key (S3) to the ON position. The "Alarm" button is red
since the "A002: OPEN GUARDS" alarm is active.
By turning the selector (S3) to the OFF position, the alarm resets itself and the button becomes green.
The above screen illustrates the operating condition in Manual STOP mode.
The above screen illustrates the operating condition in Manual START mode.
Press the START button to start the automatic cycle.
AUTO / MAN : Press this button to alternate between the MANUAL and
AUTOMATIC programs.
Press the STOP button to stop the automatic cycle.
Press the START button to switch to "CONDITION: Manual START" and
enable the belt, expulsion of the last product and the sealing function.
AUTO / MAN : Press this button to alternate between the MANUAL AND
AUTOMATIC programs.
Press the STOP button to switch to "CONDITION: Manual STOP".
The infeed belt, outfeed belt, film feeder and film winder and unwinder all run
while this button is pressed.
By pressing this key, an entire sealing cycle is performed.
By pressing this key, the final sealing process is performed and the belt
subsequently ejects the last packaged product (Pratika 56 MPS only).
38
EN