Troubleshooting - Echo CS-320 TES Bedienungsanleitung

GB
Trouble
Engine - hard to start
- does not start
Engine Fuel at carburettor
cranks
Fuel at cylinder
Spark at end of
plug wire
Spark at plug
Engine
does not
crank
Engine Dies or accelerates
runs poorly
NOTE
"ES" START
When starter grip cannot be pulled lightly, the trouble
is diagnosed as failure of engine inside. Please
consult your dealer.
If disassembled inadvertently, it can cause injury.

TROUBLESHOOTING

No fuel at • Fuel filter clogged
carburettor • Fuel line clogged
• Carburettor
No fuel at • Carburettor
cylinder
Silencer wet with • Fuel mixture is too rich
fuel
No spark at end • Ignition switch off
of plug wire • Electrical problem
No spark at plug • Spark gap incorrect
• Covered with carbon
• Fouled with fuel
• Spark plug defective
• Internal engine problem
• Air filter dirty
• Fuel filter dirty
• Fuel vent plugged
• Spark plug
• Carburettor
• Cooling system plugged
• Exhaust port/silencer
plugged
• ALL CHAIN SAW SERVICE OPERATIONS,
• FUEL VAPORS ARE EXTREMELY FLAMMABLE
47
Cause
• Clean or replace
• Clean
• Ask your ECHO dealer
• Ask your ECHO dealer
• Open choke
• Clean/replace air filter
• Adjust carburettor
• Ask your ECHO dealer
• Turn switch on
• Ask your ECHO dealer
• Adjust 0.6 to 0.7 mm
• Clean or replace
• Clean or replace
• Replace plug
• Ask your ECHO dealer
• Clean or replace
• Clean or replace
• Clean
• Clean and adjust/replace
• Adjust
• Clean
• Clean
WARNING
OTHER THAN ITEMS LISTED IN THE
OPERATOR'S MANUAL, SHOULD BE
PERFORMED BY COMPETENT SERVICE
PERSONNEL.
AND MAY CAUSE FIRE AND/OR EXPLOSION.
NEVER TEST FOR IGNITION SPARK BY
GROUNDING SPARK PLUG NEAR CYLINDER
PLUG HOLE, OTHERWISE SERIOUS PERSONAL
INJURY MAY RESULT.
Remedy
DANGER
CS-320TES/CS-350TES
E
N
G
L
I
S
H
D
E
U
T
S
C
H
E
S
P
A
Ñ
O
L