Vari BDR-620D Bedienungsanleitung Seite 27

Position STOP:
Engine is not running (position '1')
➢ Used for turning off the running engine.
➢ Putting the machine out of service.
➢ Refuelling
➢ Machine transport
Position MAX:
Engine is running at maximum rpm. (position „3" hare)
➢ Working position
Pict.3: Positions of accelerator lever
1) Upper disc
2) Blade
3) Bolt
Pict. 5: Mounting of cutting blade on the upper disc
Pict. 4: Cutting width
Pict. 7: Lubricating point
Pict. 6: Lubricating point
Pict. 13: Lubricating point
Pict. 8: Lubricating point
Pict. 9: Lubricating point
Pict. 10: Adjustment of the wheel drive tightening pulleys
Pict. 11: Disc drive clutch lever – brake
Pict. 13: V-belt tracks
Pict. 14: 1st speed - slow (turtle)
Pict. 16: 2nd speed - fast (hare)
Pict. 15: Information label - speed changing (on the gearbox cover)
Pict. 17: Safety pictogram – Combined sticker
Pict. 18: Safety pictogram - Arrow direction of turning
Pict. 19: Safety pictogram - Machine wheel drive
Pict. 20: Safety pictogram - Starting up the disc
Pict. 21: Pict. 21: Safety pictograph - Dangerous area
1) Upper gearbox cover
2) Lower gearbox cover
3) Plastic nut
4) V-belt of cutting disc drive
Pict. 12: Disassembly of the gearbox covers
Position MIN:
Engine is running at idle. (position „2" turtle)
➢ Short work break
Position CHOKE:
Engine is running. (position „4")
➢ Cold engine start
4) Washer
5) Ring
6) Nut
Location on the machine
Location on the machine
Location on the machine
Location on the machine
Location on the machine
5) V-belt of gearbox drive
6) V-belt of wheel axle drive
7) Driving double-pulley (on the gearbox)
8) Driven double-pulley (on the axle)
BDR-620D, BDR-620DB
27