Problems And Solutions; Storage; Machine Washing And Cleaning; Cover And Machine Disposal After Its Service Life Termination - Vari Bdr-620D Bedienungsanleitung

2.5.6

Problems and solutions

Problem
Cutting disc is not spinning
The cutter does not move
Engine does not start
Brake does not work
Impossible to stop the cutter
Impossible to stop the cutting
disc
Control levers do not come
back
Other defect
Tab. 8: Problems and solutions
2.5.7

Storage

Before any longer storage (e.g. at the end of the season) clean any dirt or plant remains from the cutter. Prevent all unauthorised persons from accessing the
cutter. Protect the cutter from wind but do not use airtight protection, which can cause higher corrosion.
 Check that the blades are intact and sharpen them (if damaged, exchange them).
We strongly recommend:
➢ Mothball the blades on the cutting disc.
➢ Remove all dirt and plant remains.
➢
Repair damaged places on colour parts.
➢ Empty petrol tank and carburettor (for further instructions see engine user manual).
➢ Carry out seasonal lubrication of the cutter according to Table 6.
➢ Check tyre pressure and fill the tyres to MAX level.
2.5.7.1

Machine washing and cleaning

 Follow local laws protecting water courses and other water resources from chemical contamination when cleaning the cutter.
 Never wash the engine with a stream of water! The electrical equipment of the engine might be damaged on starting the engine.
 Do not use pressure washers for cleaning the cutter.
2.5.8

Cover and machine disposal after its service life termination

You are required to carry out the package disposal after unwrapping the cutter, following national waste laws and regulations.
We recommend to follow these instructions when disposing of the machine after its service life termination:
➢ Dismount all machine parts that can still be used.
Cause
the engine is not running
wheel drive clutch lever is not pressed
insufficient belt tightening
broken belt
fallen belt
other defect
the engine is not running
wheel drive clutch lever is not pressed
insufficient belt tightening
broken belt
fallen belt
other defect
there is no petrol in the tank
petrol feed is closed
other defect
there is no axial clearance in the brake cable, the cable is tight
cam is hard to move
brake lining has deteriorated – impossible to adjust the brake
wheel drive pulley is broken
tight cable wire; bended cable
tightening pulley does not come back
tightening pulley does not come back
tight cable wire; bended cable
return spring is broken
other defect
BDR-620D, BDR-620DB
Solution
Start the engine
Press the lever
Adjust the tightening pulley
Exchange the belt with a new one
Mount the belt
Visit the service centre
Start the engine
Press the lever
Adjust both tightening pulleys
Exchange the belt with a new one
Mount the belt
Visit the service centre
Refuel
Open petrol feed
Visit the service centre
Adjust the brake
Lubricate
Visit the service centre
Exchange it with a new one
Lubricate or exchange cable
Lubricate
Lubricate
Lubricate or exchange cable
Exchange it with a new one
Visit the service centre
Visit the service centre
25