Electrical Connections - EKOM DUO Benutzerhandbuch

DUO, DUO 2V, DUO 2

ELECTRICAL CONNECTIONS

The product is equipped with a grounded plug. Insert the mains plug into a rated mains socket.
Ensure full compliance with all local electrical codes. The mains voltage and
frequency must comply with the data stated on the device's label.

 Keep the socket easily accessible to ensure that in an emergency the device can be safely
disconnected from the mains.
 Connection to the power distribution cabinet must be max.16
A.
 Connect the pin for equipotential bonding  6 mm (1) to the
electrical circuit using the defined method under valid
electrical engineering
equipotential bonding (2) is an accessory and is not provided
in the basic package. (Fig. 11)
Ensure the electrical cable does not touch hot compressor components. Risk of
electric shock!
If any electrical cord or air hose is damaged it must be replaced immediately.
 Route the power cord the rear opening in the cabinet or connect to the floor outlet (Fig. 9, 10).
Suction unit control connector
(Fig. 12)
Route the suction unit control (24 V AC/DC) cord (12) through the opening in the rear of the cabinet
(1) or the piping in the floor (11), and secure with the clips (2) located on the left panel of the cabinet
at the bottom and through the cavity (3) in the front of the cabinet. Move the sound insulation (4)
from the corners of the cabinet before inserting the cord into the clips. Remove the cover on the
electrical circuit conduit (5) and the electrical panel cover (6). Connect the suction unit control cord
to the printed circuit board as shown in the electrical diagram, insert into the cavity (3) in the front of
the cabinet, behind the sound insulation on the side of the cabinet and into the electrical conduit (7).
Ensure the electrical cable does not touch hot compressor components. It may
damage the insulation!
05/2018
regulations. The
- 25 -
socket for
Fig. 11
NP-DUO-2_05-2018-MD