Automatic Initialization Of Part-Turn Actuators - Siemens SIPART PS2 Betriebsanleitung

Operating instruction
7.2.1

Automatic initialization of part-turn actuators

Once you can move the actuator through its setting range correctly, leave it in a central position and start automatic
initialization:
1. Press the mode key
Display
2. Set the parameter to "turn" with the
Display:
3. Switch to the second parameter by pressing the mode key
The second parameter is set to 90° automatically.
Display:
4. Switch to the following display with the mode key
Display:
5. Start initialization by pressing the
Display:
During the initialization process "RUN1" to "RUN5" appear one after the other in the lower display.
.
NOTE
The initialization process can take up to 15 min depending on the actuator.
Initialization is complete when the following display appears:
The upper value shows the total angle of rotation of the actuator (example 93,5°).
After you have pressed the mode key
To exit Configuration mode press the mode key
displayed. After you have released the mode key, the unit is in manual mode.
If you want to set further parameters, use the leaflet "Operation -- a concise overview" or the Manual.
You can start reinitialization from manual or automatic mode at any time.
54
for more than 5 s. This takes you into Configuration mode.
key:
key for more than 5 s.
briefly, the following display appears:
briefly.
:
for more than 5 s. After about 5 s, the software version is
SIPART PS2 EEx d FF
A5E00351419--01