Extension Kit "Part-Turn Actuator" 6Dr4004--8D; Assembly Sequence - Siemens SIPART PS2 Betriebsanleitung

Operating instruction
3.3

Extension Kit "Part-Turn Actuator" 6DR4004--8D

The following are included in the delivery of the extension kit "Part-Turn Actuator" (see Figure 2, page 43 for item
Nos.):
Item No. Quantity
2 1
3 1
4 1
4.1 8
4.2 1
14 4
15 4
16 1
17 1
18 1
19 1
3.3.1

Assembly Sequence

(see Figure 2, page 43)
1. Place VDI/VDE 3845 mounting console ((9), actuator-specific, scope of supply of actuator manufacturer)
onto rear of positioner and secure using hexagon head screws (14) and lock washers (15).
2. Adhere pointer (4.2) onto mounting console in the center of the centering hole.
3. Push coupling wheel (2) onto positioner axis as far as possible, pull back by about 1 mm, and tighten socket--
head screw (18) using the supplied Allen key.
4. Place the driver (3) onto the end of the actuator shaft and secure using Fillister head screw (16) and washer
(17).
5. Carefully place positioner with mounting console onto the actuator such that the pin of the coupling wheel
engages in the driver.
6. Align the positioner/mounting console assembly in the center of the actuator and screw tight.
(Screws not included in delivery; they are part of the actuator mounting console!)
7. Following startup as described in Section 7: Drive actuator to end position and adhere scale (4.1) onto the
coupling wheel (2) according to the direction of rotation or the turning range. The scale is self-adhesive!
42
Designation
Coupling wheel
Driver
Multiple scale
Scale
Pointer
Hexagon head screw
Lock washer
Fillister head screw
Washer
Socket--head screw
Allen key
Remarks
Mounting on position feedback shaft of the positioner
Mounting on end of actuator shaft
Indication of actuator position, comprising 4.1 and 4.2
Different divisions
Reference point for scale (adhesive label)
DIN 933 -- M6 x 12
S6
DIN 84 -- M6 x 12
DIN 125 -- 6.4
Premounted with coupling wheel
For item 18
SIPART PS2 EEx d FF
A5E00351419--01