Automatic Initialization Of Linear Actuators - Siemens SIPART PS2 6DR50x0 serie Betriebsanleitung

Operating instructions
7. Now move the actuator into the horizontal position of the lever. The display should show a value between
P48.0 and P52.0. If that is not the case, adjust the friction clutch (8, Fig. 3) until "P50.0" is shown when the
lever is horizontal. The more precisely you achieve that value, the more accurately the positioner can deter-
mine the displacement.
7.1.1

Automatic initialization of linear actuators

If you can move the actuator correctly, leave it in a central position, and start automatic initialization:
1. Press the mode key
Display:
2. Switch to the second parameter by pressing the mode key
Display:
.
NOTE
This value must match the setting of the leverage ratio switch (7, Leaflet "Operation -- a concise
overview") (33° or 90°)
3. Switch to the following display with the mode key
Display:
You only have to set this parameter if you want to have the calculated total stroke displayed in mm at the
end of the initialization phase. To do that, select the same value in the display as the value to which you set
the driver pin on the scale of the lever.
4. Switch to the following display with the mode key
Display:
5. Start initialization by pressing the
Display:
During the initialization process "RUN1" to "RUN5" appear one after the other in the lower display.
.
NOTE
The initialization process can take up to 15 min depending on the actuator.
58
for more than 5 s. This takes you into Configuration mode.
key for more than 5 s.
briefly.
or
:
:
SIPART PS2
A5E00074600-05