Altana BYK LCS III Betriebsanleitung Seite 57

Standard Operations
5.7.1.1 Set up single wavelength mode
Options
More
Store Off/On
% Trans/Abs
λ
Wavelength
Send Data
Concentration Factor
Concentration
Resolution
Reading Mode
Recall Data
Instrument Setup
56
Press Single Wavelength in the Main Menu. Press Options for
Parameter Setup.
options.
Table 7 Single wavelength setup options
Description
For further Options
With the Store On setting, all measurement data are stored automatically. With the Store Off
setting, no measurement data are stored.
To switch to % transmittance, concentration or absorbance readings
To enter the measurement wavelength. Use the alphanumeric keypad to enter the measurement
wavelength. The entered wavelength must be in the range from
320–1100 nm.
To send data to a printer, PC or USB memory stick
Multiplication factor for converting absorbance values into concentration values.
To select the position of the decimal point in the calculated concentration readings.
Single Reading Mode: A reading is only displayed after a measurement has been carried out
(press Read; standard setting) (see
Continuous Reading Mode: After the zero measurement, all readings are displayed
automatically and continuously (see
Call up saved measurement data, wavelength scans or time courses, see
page 28.
Basic data of the instrument, see
Table 7 describes the single wavelength setup
section 5.7.1.2 on page 58).
section 5.7.1.3 on page 58).
section 5.2 on page 17.
section 5.3 on