Interfaces - Altana BYK LCS III Betriebsanleitung

3.4 Interfaces

1 USB type A
2 USB type B
The LCS III has two USB interfaces as a standard feature, located
on the back of the instrument
is used for communications with a printer, USB memory stick or
keyboard. A USB memory stick is used to update instrument
software.
The USB Type B interface is used for communications with a PC.
The optional Data Trans software must be installed on the PC for
this use.
A USB hub may be used to connect several accessories at a time.
Note: USB cables must not be longer than 3 meters (10 feet).
These USB interfaces enable data and graphics to be output to a
Printer and a PC and upgrade instrument software (see
section 6.1.2 on page 72).
Figure 2 Interfaces
3 Plug in power supply
4 On/Off switch
Installation
(Figure 2). The USB Type A interface
9