Technical Specifications; Features; Performance; Electronic Control - Storch PS 12 Bedienungsanleitung

7. Technical data

Mains voltage
Power supply cable
Output
Fuse
Rotational speed
Rotational speed
Delivery performance
Max. delivery range (pasty)
Max.delivery height (pasty)
Maximum grain size
Material hopper fill volume
Weight (without pump unit)
Dimensions
Sound pressure level
Max working pressure
Recommended air flow capacity of compressor:
* Depending on the material; see the material manufacturer's specifications
All information is without guarantee! Subject to technical modifications and errors!
(8) Safety instructions
To ensure safe operation of the machine, the most
important safety rules are described in the following.

8.1. Basic safety instructions

8.1.1. Notices on the machine
Safety instructions on the machine draw the operator's
attention to imminent risks.
Observe all safety and hazard warning signs attached to
the machine!
• Always keep the safety and hazard warning signs in a
clearly legible condition!
8.1.2. Notes in the operating instructions
Safety instructions in the operating instructions draw the
operator's attention to imminent risks. Please note
• all technical instructions and hazard warnings in these
operating instructions.
• Chapter "Training and qualification of operating staff"
230 V, 50 / 60 Hz
1 Phase N. PE via safety cable 2.5 mm
1.5 kW
16 A
0 - 200 rpm
Controllable via motor potentiometer
0 - 12 l/min*
With screw pump D 6 - 3 short design
approx. 20 m*
approx. 10 m*
3 mm*
approx. 60 l
approx. 65 kg
Length: 1,300 mm
Width: 580 mm
Height: 690 mm
< 80 dBA
16 bar
200 l output power
8.1.3. Checks before starting work
Defects or damage can endanger the safety of operating
staff and impair the functional capability of the machine.
• Before starting work, check the machine for visible
damage or defects!
• Do not put the machine into operation if you detect any
damage or defects on the machine!
• Make sure that damage and defects are eliminated
without delay.
8.1.4. Conversion and modifications
Conversion and modifications can endanger the safety of
operating staff and impair the functional capability of the
machine.
Do not convert, extend or modify the machine!
87
2
Translation of the original instruction