LR-Cal LPC 200 Betriebsanleitung Seite 6

Pressure Calibrator
LPC 200
8. The display window is made of glass (which can splinter). Unless there is no
GB
possibility of this glass breaking during operation, anyone in the close vicinity of
the equipment must wear eye protectors, both before and during operation.
9. Test and calibration assemblies must always be constructed and also dis-
mantled in an unpressurised state (atmosphere).
10. If the LPC-2 Pressure Sensor is used for applications with oil as the fluid
media, subsequent use with fuels or gases is prohibited, since this could cause
an explosion and risks harm to both people and machinery.
11. If the equipment is damaged and might no longer operate safely, it should be
taken out of use and securely marked in such a way that it will not be again.
Operator safety may be at risk if:
There is visible damage to the device

The device is not working as specified

The device has been stored under unsuitable conditions for an extended period

of time.
If there is any doubt, please return the device to the manufacturer for repair or
maintenance.
1. Customers must not attempt to alter or repair the device themselves. Please
return the device to the manufacturer for any repair or maintenance.
13. Any operation not included in the following instructions or outside the specifi-
cations must not be attempted.
6 LR-Cal Operating Instructions Pressure Calibrator LPC 200