Re-Calibrating And Servicing; Transport Of The System Des Gerätes - LR-Cal LPC 200 Betriebsanleitung

Pressure Calibrator
LPC 200

8. Re-calibrating and servicing

GB
We recommend having the system re-calibrated by the manufacturer at regular
intervals of approx. 1 months. Every re-calibration at the factory also includes a
comprehensive and free checking of all system parameters.
Maintenance advice

Both the LPC 200 and sensors are manufactured using solid-state technology,
and contain no moving parts which could wear. If the instrument housing has
been opened, the warranty becomes invalid.
To clean the membrane keyboard and the display, use only customary plastic or
glass cleaning agents in compliance with the guidelines of the manufacturer. Use
clothes which are not prone to generate fluffs.
9. Transport of the system
Please follow the following instructions to prevent damage.
1. Wrap the system in antistatic plastic foil.
. Using the insulating material, place the system in the box in such a way that
there is about the same amount of insulating material on all sides of the transport
box.
30
Before cleaning the surface of the instrument, it has to sure
that it is not pressurized, the power switched off and the
power supply disconnected.
The electrical connections along the upper edge of the instru-
ments should not come into contact with a damp cloth.
Before the system is shipped all remains of any medium stuck
to it must be removed. This is particularly important if the
medium is a health hazard such as a corrosive, toxic, carcino-
genic, radioactive, etc.
LR-Cal Operating Instructions Pressure Calibrator LPC 200