Pressure Units; Measuring Signal Processing - LR-Cal LPC 200 Betriebsanleitung

Pressure Calibrator
LPC 200

6.3 Pressure units

Depending on the measuring range of the current pressure sensor the units bar,
mbar, kPa mmHg, inHg or psi can be selected via the UNIT key.
Repeat pressing the UNIT key until the desired unit is displayed (ring shift).
Table of available units including their conversion factors in relation the unit
bar:
bar
mbar
psi
inHg (60 °F)
mmHG (0 °C)
kPa

6.4 Measuring signal processing

The default value of the filter for the measuring signal processing/smoothing is
factor "3" and can only be changed into 1 to 5 by means of the LPC-Cal PC
software (available as an option).
1 = no filter, ... , 5 = high filter
LR-Cal Operating Instructions
1.00000E+00
1.00000E-03
6.89475E-0
3.37690E-0
1.333E-03
1.00000E-0
Pressure Calibrator LPC 200
GB
1