Data Logger (Logger) - LR-Cal LPC 200 Betriebsanleitung

Pressure Calibrator
LPC 200

6.6.3 Data logger (LOGGER)

Different configurations can be carried out via the FUNC key, e.g. operating the
integrated data logger.
Activating the data logger (LOGGER) menu item (USB) by:
pressing the FUNC key three times* (directly in the measuring mode).
* If you already are in a "FUNC menu item", press the FUNC key until the "LOGGER" menu item appears.
In the "LOGGER" "FUNC menu item" data recording is started via the MODE key,
interrupted via the TARE key and stopped via the UNIT key.
a = currently stored points
1
a = max. number of possible stored points

b = cycle time (changeable via the optional "LPC-Cal" PC software)
The LPC-Cal PC software is used to read out and display
the saved logger data and to configure the logger. Moreover LPC-
Cal" is also used to set the cycle time (see point: b) from 1 sec up
to 3600 sec.
Return to the measuring mode by pressing this key several times.
FUNC
LR-Cal Operating Instructions Pressure Calibrator LPC 200
GB
a /a
1 
b
5