Cleaning The Exhaust Air Fi Lter - Cleanmaxx BT-ZW-9028-E08 Gebrauchsanleitung

Cleaning the exhaust air fi lter
The HEPA fi lter may lose some of its colour over time. This is normal and does
not have any adverse effect on function.
1. The exhaust air fi lter is a HEPA fi lter and sits in the rear
part of the vacuum cleaner. Open the fl ap at the rear sec-
tion of the vacuum cleaner by pulling the release button
back and lifting the fl ap.
2. Remove the HEPA fi lter by pushing the catch inwards and
pulling the HEPA fi lter up and out of the device. Clean
the HEPA fi lter under clear running water. Then allow the
HEPA fi lter to dry. CAUTION: Do not under any circum-
stances clean the fi lter in a washing machine or dish-
washer! Then shake off any excess water and let the fi lter
dry completely in the air before you insert the fi lter again.
3. Once the HEPA fi lter has dried completely, you can re-
insert it. Make sure that you insert the two catches in the
intended openings fi rst and that you push the HEPA fi lter
down then. It must audibly lock into place. Then you can
close the fl ap again.
26