Cleaning The Hepa Exhaust Air Fi Lter; Cleaning The Housing And Nozzles; Cleaning The Turbo Nozzle - Cleanmaxx CP-CY4503EP-6 Gebrauchsanleitung

Cleaning the HEPA exhaust air fi lter
The HEPA exhaust air fi lter is situated behind the protective grill on the back of the
vacuum cleaner.
D
Next, shake off any surplus water and leave the fi lter to air dry completely before
replacing it in the device.
3. Brush or wipe the fi lter compartment if required.
4. Place the dry fi lter back in the fi lter compartment.
5. Then place the exhaust hatch in the device and close the hatch. The hatch must
audibly lock into place.
If the HEPA exhaust air fi lter is damaged or worn you can order a new fi lter at
www.service-shopping.de.

Cleaning the housing and nozzles

• If needed, clean the housing with a damp, soft cloth.
• Regularly remove hair and lint from the nozzles.
Please note the instructions in the section "Cleaning the turbo nozzle" when cleaning
the turbo nozzle.

Cleaning the turbo nozzle

1. Pull up the exhaust hatch latch (D) and remove the hatch
simultaneously.
2. Remove the fi lter from the fi lter compartment and tap
it out over a garbage bin. If necessary, clean it with a
soft brush. You can also rinse the fi lter out under clear,
lukewarm warm water.
Attention: Do not use any cleaning products!
1. If hair or fl uff becomes caught in the cogs of the turbo nozzle
you can open the cog cover on the base of the nozzle.
2. Pull out any hair or dirt caught in the cogs.
3. Close the cog cover again.
26