Cleaning The Exhaust Air Fi Lter; Cleaning The Hepa Motor Fi Lter - Cleanmaxx VC4807T-240 Gebrauchsanleitung

5. The HEPA dust fi lter is surrounded by a fi nely woven particulate dust fi lter. Remove it by
opening the Velcro
and let it allow to dry completely.
6. Tap the HEPA dust fi lter out over an open dustbin. Clean the fi lter using a brush if necessary.
Never clean the HEPA dust fi lter with water!
7. Put the particulate dust fi lter back on the HEPA dust fi lter, when the particulate fi lter is
completely dry, and fasten it with the help of the Velcro
8. Place the HEPA dust fi lter back into the dust container by turning it shut in the clockwise
direction. Make sure that the HEPA dust fi lter is correctly locked in place.
9. Place the fl ap with the HEPA dust fi lter back into the dust container. Hook the fl ap into the
eyelets on the side of the dust container and then shut it with the catch on the opposite side.
Make sure that the dust container is shut correctly.
10. Only place the dust container back into the device when all fi lters have been inserted cor-
rectly at the right place.
Cleaning the exhaust air fi lter
1. The exhaust air fi lter is located on the back of the dust container.
3. Rinse the exhaust air fi lter with clear water and allow it to dry completely.
4. Insert the exhaust air fi lter back into the dust container and close the fl ap of the cover.
5. Only place the dust container back into the device when all fi lters have been inserted cor-
rectly at the right place.
Cleaning the HEPA motor fi lter
2. Remove the HEPA motor fi lter.
08200_DE-GB-FR-NL_V1.indb 29 08200_DE-GB-FR-NL_V1.indb 29
4. Remove the fi lter by turning it anticlockwise.
® fastener. Remove dust and dirt, if necessary, rinse it with clear water
2. Open the fl ap of the fi lter cover and remove the exhaust air
fi lter.
1. Remove the exhaust air grille from the back section of the de-
vice.
29
fastener.
®
31.10.12 09:24 31.10.12 09:24