Supporting The Motorcycle; Front Wheel; To Remove The Front Wheel (Tt-R125 / Tt-R125E) - Yamaha TT-R125E(Y) Bedienungsanleitung

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear wheel
or performing other maintenance
requiring the motorcycle to stand upright.
Check that the motorcycle is in a stable
and level position before starting any
maintenance. A strong wooden box can
be placed under the engine for added
stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack
under the frame in front of the rear
wheel.
2. Raise the front wheel off the ground
by using a motorcycle stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a
motorcycle stand is not available, by
placing a jack either under each side of
the frame in front of the rear wheel or
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24350 under each side of the swingarm.

Front wheel

To remove the front wheel
(TT-R125 / TT-R125E)
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the brake cable locknut
and the brake cable free play
adjusting nut at the front wheel hub.
2. Loosen the locknut at the brake
lever, and then turn the adjusting
bolt in direction (a).
1. Locknut
2. Adjusting nut
EAU24360
EAUW0531
EWA10821
1. Adjuster
2. Locknut
1. Axle nut
6 - 2 8
3. Disconnect the brake cable from
the front brake lever, then from the
brake camshaft lever.
4. Loosen the axle nut.
5. Lift the front wheel off the ground
according to the procedure on page
6-28.
6. Remove the axle nut and washer,
and then pull the wheel axle out.
6