Adjusting The Shock Absorber Assembly - Yamaha TT-R125E(Y) Bedienungsanleitung

Adjusting the shock
absorber assembly
This shock absorber assembly is
equipped with a spring preload adjusting
nut, a rebound damping force adjusting
dial and a compression damping force
adjusting knob.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Spring preload
1. Locknut
2. Adjusting nut
1. Loosen the locknut.
INSTRUMENT AND CONTROL FUNCTIONS
EAUW0471 2. To increase the spring preload and
thereby harden the suspension,
turn the adjusting nut in direction
(a). To decrease the spring preload
and thereby soften the suspension,
turn the adjusting nut in direction
(b).
The spring preload setting is
ECA10101
determined by measuring distance
A, shown in the illustration. The
shorter the distance A is, the
higher the spring preload; the
longer distance A is, the lower the
spring preload.
Spring preload:
Minimum (soft):
TT-R125 / TT-R125E / TT-R125LW
Distance A = 175 mm (6.89 in)
TT-R125LWE
Distance A = 167.5 mm (6.59 in)
Standard:
TT-R125 / TT-R125E / TT-R125LW
Distance A = 165 mm (6.50 in)
TT-R125LWE
Distance A = 160.5 mm (6.32 in)
Maximum (hard):
TT-R125 / TT-R125E / TT-R125LW
Distance A = 155 mm (6.10 in)
TT-R125LWE
Distance A = 147.5 mm (5.80 in)
Rebound damping force
(TT-R125LWE)
1. Adjuster
To increase the rebound damping force
and thereby harden the rebound
damping, turn the adjusting dial in
direction (a). To decrease the rebound
damping force and thereby soften the
rebound damping, turn the adjusting dial
in direction (b).
3 - 8
3. Tighten the locknut to the specified
torque. NOTICE: Always tighten
the locknut against the adjusting
nut, and then tighten the locknut
to the specified torque.
Tightening torque:
Locknut:
42 Nm (4.2 m.kgf, 30 ft.lbf)
[ ECA11241]
3