To Install The Front Wheel (Tt-R125 / Tt-R125E); To Remove The Front Wheel (Tt-R125Lw / Tt-R125Lwe); To Install The Front Wheel (Tt-R125Lw / Tt-R125Lwe) - Yamaha TT-R125E(Y) Bedienungsanleitung

PERIODIC MAINTENANCE AND ADJUSTMENT
7. Remove the wheel and the brake
shoe plate.
To install the front wheel
(TT-R125 / TT-R125E)
1. Install the brake shoe plate into the
wheel.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake shoe
plate fits over the retainer on the fork
leg.
6
1. Slot
2. Retainer
3.Insert the wheel axle, and then
install the washer and axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
wheel hub and then at the front
EAUW0550 brake lever.
6. Tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
45 Nm (4.5 m.kgf, 32 ft.lbf)
7. Adjust the brake lever free play.
(See page 6-17.)
8. Push down hard on the handlebar
several times to check for proper
fork operation.
To remove the front wheel
(TT-R125LW / TT-R125LWE)
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure on page
6-28.
1. Washer
2. Axle nut
EAUW0541
EWA10821
To install the front wheel
(TT-R125LW / TT-R125LWE)
TIP
Make sure that there is enough space
between the brake pads before inserting
the brake disc into the caliper.
6 - 2 9
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed
together with the brake disc,
otherwise the brake pads will be
forced shut.
[ECA11071]
1. Lift the wheel up between the fork
legs.
EAUW0560