Troubleshooting - Yamaha TT-R125E(Y) Bedienungsanleitung

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7. Remove the wheel.
To install the rear wheel
1. Insert the wheel axle from the left-
hand side.
TIP
Make sure that the drive chain adjusting
plates are installed with the punched
sides facing to the outside and that the
6
slot in the brake shoe plate fits over the
retainer on the swingarm.
1. Groove
2. Retainer
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-21.)
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
4. Tighten the axle nut to the
EAUW0700
specified torque.
Tightening torque:
Axle nut:
60 Nm (6.0 m.kgf, 43 ft.lbf)
5. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
6. Adjust the brake pedal free play.
(See page 6-18.)

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems
yourself. However, should your
motorcycle require any repair, take it to
a Yamaha dealer, whose skilled
technicians have the necessary tools,
experience, and know-how to service the
motorcycle properly.
Use only genuine Yamaha replacement
parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the area,
6 - 3 1
EAU25851
EWA15141