Yamaha TT-R125E(Y) Bedienungsanleitung Seite 71

MOTORCYCLE CARE AND STORAGE
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge, and
then rinse thoroughly with clean water.
Use a toothbrush or bottlebrush for hard-
to-reach areas. Stubborn dirt and insects
will come off more easily if the area is
covered with a wet cloth for a few
minutes before cleaning.
After riding in the rain or near the sea
Since sea salt is extremely corrosive,
carry out the following steps after each
ride in the rain or near the sea.
1. Clean the motorcycle with cold
water and a mild detergent, after
the engine has cooled down.
NOTICE: Do not use warm water
7
since it increases the corrosive
action of the salt.
2. Apply a corrosion protection spray
on all metal, including chrome- and
nickel-plated, surfaces to prevent
corrosion.
After cleaning
1. Dry the motorcycle with a chamois
or an absorbing cloth.
2. Immediately dry the drive chain
and lubricate it to prevent it from
rusting.
3. Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system.
4. To prevent corrosion, it is
recommended to apply a corrosion
protection spray on all metal,
including chrome- and nickel-
plated, surfaces.
5. Use spray oil as a universal cleaner
to remove any remaining dirt.
6. Touch up minor paint damage
caused by stones, etc.
7. Wax all painted surfaces.
8. Let the motorcycle dry completely
before storing or covering it.
]
[ ECA10791
Contaminants on the brakes or tires
can cause loss of control.
Make sure that there is no oil or
wax on the brakes or tires.
If necessary, clean the brake
discs and brake linings with a
regular brake disc cleaner or
acetone, and wash the tires with
warm water and a mild
detergent. Before riding at
NOTICE
EWA11131
TIP
Consult a Yamaha dealer for advice on
what products to use.
7 - 2
higher speeds, test
motorcycle's braking
performance and cornering
behavior.
Apply spray oil and wax
sparingly and make sure to wipe
off any excess.
Never apply oil or wax to any
rubber and plastic parts, but treat
them with a suitable care
product.
Avoid using abrasive polishing
compounds as they will wear
away the paint.
the
ECA10800