Initial Operation Of The Transmitter; A) Inserting The Batteries/Rechargeable Batteries; Charging Rechargeable Batteries In The Transmitter - Reely Cessna Bedienungsanleitung


9. Operation of the Transmitter
In the operating instructions, the numbers in the text always refer to the figure opposite or the figures within the section. Cross-references to other
figures will be indicated by the corresponding figure number. Upon delivery, the transmitter is set to mode II. In this mode, the left control stick
controls the rudder and motor speed, and the right control stick controls the aileron and elevator.

a) Inserting the Batteries/Rechargeable Batteries

For the power supply of the transmitter you will need 4 alkaline batteries (e.g.
Conrad Item No. 652507, pack of 4, order 1) or rechargeable mignon size
batteries (AA). For ecological and also for economical reasons it is recommended
to use rechargeable batteries, since they can be recharged.
The battery compartment lid (1) is on the back of the transmitter. Press the
corrugated area (2) and push off the lid downwards. Now insert the 4 batteries
or rechargeable batteries into the battery compartment.
Observe the correct polarity of the individual cells. The polarity is indicated (3)
at the bottom of the battery compartment.
Then slide the lid of the battery compartment back on from the bottom until the
locking mechanism engages.
b) Charging Rechargeable Batteries in the Transmitter
When using the remote transmitter with rechargeable batteries, you can attach
a charging cable to the charging jack (1) while the transmitter is switched off to
charge the rechargeable batteries with a suitable charger (not part of the delivery)
directly in the transmitter.
Attention!
If batteries are inserted in the transmitter a charger must not be
connected. Conventional batteries (1.5 V) must not be recharged;
there is a risk of fire and explosion!
Only charge rechargeable batteries intended for that purpose!
When connecting a charger cable, imperatively observe the correct polarity of
the connecting plug. The outer contact of the charging socket must be connected
to the negative terminal (-) and the inner contact to the positive terminal (+) of
the charger. The charging current should correspond to approximately 1/10 of
the capacity value of the inserted rechargeable batteries. In rechargeable
batteries with a capacity of 2000 mAh this corresponds to a charging current of
approx. 200 mA and the charging time is approx. 14 hours.
In order to avoid damage of internal printed conductors and connections, please
do not use fast chargers.
With NiCd rechargeable batteries a memory effect can occur. If NiCd rechargeable batteries are charged when they are not fully discharged, their capacity
diminishes in the course of time. Thus, such rechargeable batteries must be discharged with an appropriate charger outside of the transmitter and then charged
completely again.
Figure 3
Figure 4
37