C) Mounting The Vertical Tail Unit - Reely Cessna Bedienungsanleitung

Place the elevator as indicated in the adjacent figure and press the glue areas
together.
This work step is very important for the flight properties of your
model, since any deviations may cause negative flight properties!
c) Mounting the Vertical Tail
Pull off the two protective adhesive film strips (2) on the two sides of the vertical
tail (1) (displayed in grey).
Push the vertical tail into the slot (1) at the end of the fuselage from behind.
Bend the slot open slightly for this to ensure that the adhesive tape does not
inadvertently stick to the wrong place.
Important:
The rudder horn (2) must be on the left side when viewed in flight
direction.
40
A
A = A'
A'
Figure 6c
Figure 7a
Figure 7b