B) Switching On The Ir Transmitter; C) Operation Of The Ir Transmitter - Reely 1537717 Bedienungsanleitung

b) Switching on the IR Transmitter

First push the control lever for the pitch function to the bot-
tom position (also see figure 1, item 5).
Slide the on/off switch (see figure 1, item 6) from the lower
position "OFF" to the upper position "ON".
The LED of the operation control display (2) flashes quick-
ly and shows that the transmitter is sufficiently supplied
with voltage.
Slide the control stick for the pitch function (also see figure
1, item 5) to the top position and then right back to the bot-
tom one. The LED of the operating control display (2) now
must be lit permanently.
Attention!
If the LED of the operating control display is only lit weakly anymore and starts to flash slowly (below ap-
prox. 6 V), the inserted batteries must be replaced by fresh ones.

c) Operation of the IR Transmitter

Hold the IR transmitter in both hands and operate the two control levers (see figure 1, item 3 and 5) with your thumbs.
Signal transmission from the transmitter to the model takes place via an IR light signal (invisible to the hu-
man eye) instead of by radio.
It is therefore important that your IR transmitter diodes (see figure 1, item 1) are always "targeted" at the
model to achieve best signal transfer.
Obstacles between the transmitter and model can impair signal transmission. Therefore, always observe a
direct "line of sight" between the transmitter and the model helicopter.
Figure 3
29