Controls Of The Remote Control - Reely Massive Bedienungsanleitung



7. Controls of the remote control

1 Telescopic aerial
If needed, the telescopic aerial can be screwed off for
transport.
2 Eyelet for carrying strap
3 Slide switch for CH1/reverse (steering)
If the steering response is exactly opposite to the
movement of the control wheel (8), you can reverse
the movement using the slide switch.
4 Slide switch for CH2/reverse (drive)
This inverts the response of the drive (forward/reverse)
to the throttle (13).
5 Three LEDs (red, yellow, green) to indicate the battery
state
If all three LEDs are lit, the batteries are full.
If the green LED goes out (only the red and the yellow
LEDs are lit), the batteries are low and should be
exchanged soon.
If only the red LED is lit, the batteries are empty and
must be exchanged.
6 Replaceable crystal
The remote control and the receiver must be equipped
with a crystal of the same frequency.
Transmitter crystals for the remote control are usually
labelled "TX". Receiver crystals are usually labelled
"RX". Do not mix up the two crystals!
7 On/off switch
This slide switch turns the transmitter on or off. If the slide switch is moved towards the control wheel (8), the
transmitter is switched on. Never turn off the transmitter while the vehicle is in operation!
8 Control wheel for steering
9 Steering trim control
This trim control sets the directional stability of the vehicle. With the vehicle standing, put the front wheels in a
straight position. A more precise setting of directional stability is carried out later when driving the vehicle.
10 Trim control for neutral position of the drive
To make sure the vehicle stops when the throttle (13) is released, neutral position can be set exactly using this trim
control.
1
2
8
6
7
15
12
3 4 5
9 10
11
13
14
29