Standard Accessories; Battery Removal/Installation - Hitachi CS 36DL Bedienungsanleitung

English
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

1 Charger (UC36YRSL)
2 Battery (BSL3620)
3 Battery cover
4 Chain case
5 File set
6 Oil feeder
7 Hexagonal bar wrench
Standard accessories are subject to change without
notice.
APPLICATIONS
○ Cutting of timber/logs
○ Pruning, felling of garden trees
Before
charging
While
The
charging
pilot lamp
lights or
Charging
blinks in
complete
red.
Charging
impossible
The
pilot lamp Overheat
lights in standby
green.
(2) Regarding the temperatures of the rechargeable
battery
The temperatures for rechargeable batteries are as
shown in Table 2, and batteries that have become hot
should be cooled for a while before being recharged.
Table 2 Recharging ranges of batteries
Rechargeable batteries
BSL3620
UC36YRSL
14.4 V – 36 V
0.7 kg
CS36DL
LBR
1
1
1
1
1
2
1
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Flickers
Lights continuously
Lights
Temperatures at
which the battery
can be recharged
0°C – 50°C

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the housing tightly and push the battery latches to
remove the battery (see Fig. 4).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 4).
NN
CHARGING
–
Before using the power tool, charge the battery as follows.
–
1. Connect the charger's power cord to a receptacle.
When connecting the plug of the charger to
–
a receptacle, the pilot lamp will blink in red
1
(At 1-second intervals).
2. Insert the battery into the charger.
1
Firmly insert the battery into the charger until the line is
2
visible, as shown in Fig. 5, 6.
3. Charging
1
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 1
(3) Regarding recharging time
Depending on the combination of the charger and
batteries, the charging time will become as shown in
Table 3.
Table 3 Charging time (At 20°C)
Battery
BSL3620
NOTE
The charging time may vary according to temperature
and power source voltage.
10
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).
Charger
UC36YRSL
Approx. 60 min.