Wolf Garten CSB36 Originalbetriebsanleitung Seite 29

Operation
Manually activating the chain brake
 Tilt the hand guard a towards the saw
 
rail tip .
Loosening the chain brake:
 Pull the hand guard
handle   .
Before using the unit, always check that
the hand guard engages forwards and
backwards.
Checking the chain brake
 Place the chain saw on a secure surface.
 Loosen the chain brake.
 Hold the chain saw with both hands.
 Switch the chain saw on. The saw chain runs.
 Tilt the hand guard a towards the saw
 
rail tip .
The chain must stop immediately!
Otherwise, do not use the chain saw and have
it repaired by a qualified technician or a service
centre.
 After work, regularly remove sawdust and saw
waste from the visible mechanisms of the chain
brake.
Lubricating the chain
Attention!
The unit may be operated with adequate
chain lubricating oil only. Inadequate
lubrication will reduce the service life of
the power tool.
 Check the amount of oil on the oil level indicator

.
Topping up the chain oil
Attention! Fill the unit only with oil used
specifically for lubricating cordless saw
chains. Avoid spilling oil. Always wipe up any
spilled oil.
– Do not use waste oil.
– An oil other than the one recommended may
damage the rail, the chain and the lubricating
system.
Tank volume 180 ml, enough for approx. 250 cuts.
 Check on the transparent oil level indicator
whether there is still adequate chain oil for
lubrication.
 Unscrew the oil tank cap.
 Carefully pour in the chain lubricating oil until it
reaches the upper mark on the oil level indicator.
 Tighten the oil tank cap by hand.
Check the chain oil level even during operation and
top up with chain oil if required.
Operating instructions for chain saw

towards the front

Attention!
Ensure that dirt does not get into the oil tank.
Recommendation:
To prevent damaging the environment, we recom-
mend using a plant-based bio-chain lubricating oil.
Checking the chain lubrication
 Start the unit (see section "Switching on and off").
 Hold running saw chain for some time approx.
15 cm above a suitable surface. If there is
adequate chain lubrication, the oil which is
ejected by the saw chain will form a light trail.
Switching on and off
Switching on
 Ensure that the chain brake is released before
starting the chain saw. To do this, pull the hand
guard back towards the front handle
 Hold the chain saw firmly with both hands
and ensure that there are no people (particularly
children) or animals in the immediate vicinity.
 Press the release button
 Press the rear On/Off switch
 Release the release button
Switching off
 Release the On/Off switch
Working with the chain saw
Always hold the chain saw firmly with both hands.
Hold the front handle firmly with your left hand and
the rear handle with your right hand. This also applies
to left-handed users
 Before switching on the chain saw, ensure that
it is completely assembled.
 The chain saw is designed for sawing wood and
felling trees.
 Only fell trees which have a trunk diameter less
than the sword length of the chain saw.
 Use the chain saw only at reasonable times of the
day and not early in the morning or at night when
you may disturb people.
Before using the unit

 Check the saw chain and saw rail for damage.
 Check the chain tension.
 Check the chain lubrication.
 Check that the hand guard of the chain brake
engages forwards and backwards.
 Check that the chain brake functions.




and hold down.
 .

again.

.


.
English
.

25