Operation - Wolf Garten CSB36 Originalbetriebsanleitung

English

Operation

Operating times
 Observe the regional regulations.
 Enquire at your local authority regarding the
operating times.

Charging
After approx. 45 minutes the 3 Ah battery has a
charge capacity of 80% and is fully charged after
approx. 70 minutes. After approx. 80 minutes the
5 Ah battery has a charge capacity of 80% and is fully
charged after approx. 110 minutes.
 Use only the original WOLF-Garten charger
(part no. see "Spare parts" list)!
 Use the charger in dry rooms only!
 Press on the yellow button to detach

the battery .
 Take the battery out of the unit using your other

hand .
 Connect the charger to the socket
 
(~230 V) .
 Connect the battery to the adapter

of the charger
 Re-insert the fully charged battery into the unit
Information about charging
– The red LED indicates that the charger is
connected to the mains voltage (~230 V).
When the battery has been inserted:
– The green flashing LED indicates the charging
process.
– The green LED indicates that the charging
process is complete and the battery is fully
charged.
– The red flashing LED indicates an error message.
Flashes slowly = battery is too warm.
The charging process starts automatically at the
correct operating temperature.
Flashes quickly = battery is defective.
Have battery tested at a service centre.
– The red LED indicates an error message:
Battery is not being charged. Battery has not
been inserted correctly or the contacts are dirty.
24
.
General information about the battery
 If the battery voltage is low, the unit switches off
automatically. In this case recharge the battery.
 Charge lithium-ion batteries before long breaks,
e.g. prior to storage in the winter.
 The lithium-ion battery can be charged whatever
the battery charge and charging can be inter-
rupted at any time without damaging the battery
(no memory effect).
Charge indicator lamp
The battery has a charge indicator lamp which
indicates the charge capacity of the battery.
 Press the small black button on the battery
to read off the charge capacity.
 Now pay attention to the LED display of the
battery.
Information on the charge indicator lamp
– A green LED indicates that the battery has
a charge capacity of only max. 33% and should
be recharged as soon as possible
– Two green LEDs indicate that the battery has
 .
a charge capacity of 66%
– When all LEDs light up green, the battery
has a charge capacity of 100% and is fully
 
charged
– If a red LED is lit, have the battery tested by
a qualified technician or a service centre.

Chain brake
The chain saw features a safety chain brake which
stops the chain within a fraction of a second in the
event of a kickback.
Before using the chain saw, always check
that the chain brake is in perfect working
order. Otherwise, do not use the chain saw
and have it repaired by a qualified technician
or a service centre.
If a kickback occurs, the chain brake is automatically
actuated by touching the hand guard with your left
hand.
Therefore always hold the chain saw firmly
with both hands. Note that the chain brake
does not offer full protection.

 .
.
Operating instructions for chain saw
Operation

 .