D) Inserting And Replacing The Rechargeable Battery; E) Charging The Rechargeable Battery - VOLTCRAFT IR-1600 CAM Bedienungsanleitung

d) Inserting and replacing the rechargeable battery

• The enclosed li-ion battery must be inserted first at initial commissioning. To open the battery compartment, pull
the battery compartment lid (10) away forwards. The battery compartment lid is unlocked. Fold open the battery
compartment lid (10) forwards. Connect the plug of the rechargeable battery to the pug-in socket in the battery
compartment in the correct polarity. The pug is designed so that the rechargeable battery can only be connected
in the proper polarity. Do not apply any force when plugging in the rechargeable battery.
• Close the battery compartment again by folding shut the battery compartment lid (10). Observe that the cables are
not caught and the lock latches.
• Do not leave the rechargeable battery in the meter during longer measuring breaks (approx. >2 weeks), since
even leak-protected rechargeable batteries may corrode and release chemicals that may harm your health or
destroy the device.
A matching li-ion spare battery of type 18500 is available under the order number: Item no. 1233684 (please
order 1x).
Other rechargeable battery types or non-rechargeable batteries must not be used.

e) Charging the rechargeable battery

The enclosed li-ion battery must be fully charged first at initial commissioning.
It can be charged at any USB interface or the enclosed USB mains unit.
Charge the rechargeable battery no later than when the battery symbol shows no fill bars in the display anymore.
Charged
Proceed accordingly to charge.
• Open the rubber cover at the bottom of the meter and connect the enclosed USB charging cable to the mini USB
charge socket (17) at the meter. The plug will only fit into the charge socket in the correct orientation.
• Plug the USB plug of the charging cable into an active USB socket at a computer or connect the plug to the
enclosed USB mains unit. Charging commences as soon as the mains unit is plugged into a mains socket.
• The display shows charging by the filling (pulsating) battery symbol. If the fill bar is continually visible, charging is
completed. The device can be disconnected from the charge cable.
• Pull the USB mains unit from the socket when it is not needed for charging.
Flat
49