Maintenance And Cleaning; Replacing The Battery; Eléments De Commande - VOLTCRAFT IR-364 Bedienungsanleitung

Maintenance and cleaning

Blow loose dirt particles from the IR lens (12). Brush off any remai-
ning dirt using a fine lens brush. Wipe the surface of the device with
a slightly damp cloth. Only use water to moisten the cloth. Do not
use chemicals or cleaning agents when cleaning.

Replacing the battery

The IR-364 requires an alkaline 9 V com-
pound battery type 006P, or similar types
such as IEC6F22 and NEDA1604. If the
voltage drops below the required value,
the LCD display indicates the symbol for
flat batteries „Low Bat" (23). When this
occurs, you should change the battery.
Proceed as follows to replace the battery:
- Open the battery compartment (5) by fol-
ding the out lid of the battery compart-
ment away from the handle, as shown in
the illustration.
- Replace the battery with a new one of
the same type, and fold the lid of the
battery compartment back onto the
handle.
Do not leave flat batteries in the measuring device. Even
batteries protected against leaking can corrode and
release chemicals which may be detrimental to your
health or which may damage the device.
30
Avertissement concernant le laser !
Ne dirigez jamais le rayon laser directement ou indirec-
tement vers les yeux via des surfaces réfléchissantes.
Le rayonnement laser peut occasionner des dommages
oculaires irréparables. En cas de mesures à proximité
de personnes, il convient de désactiver le rayon laser.
Eléments de commande
1. Ecran LCD
2. Flèche « up » (haut)
3. Touche « MODE »
4. Prise femelle pour sonde
de température de type K
5. Logement des piles
6. Touche laser/Backlight
(rétroéclairage)
7. Touche de mesure
de la température
8. Flèche « down » (bas)
9. Interrupteur à coulisse °C/°F
10. Interrupteur à coulisse
mesure continue
11. Interrupteur à coulisse
« Alarme marche/arrêt »
12. Orifice du capteur infrarouge
13. Orifice de sortie du laser
39