Herunterladen Diese Seite drucken

Analogue Output; Maintenance And Cleaning; Replacing The Battery; Contenu De La Livraison - VOLTCRAFT IR-365RF Bedienungsanleitung

Infrarot-thermometer

Werbung

Analogue output

The IR-365RF is fitted with an analogue output to which optional graph plotters can
be connected. When the radio transmission is active, a voltage of 1 mV per °C of the
measured temperature value is emitted from the analogue output (28).

Maintenance and cleaning

Blow loose dirt particles from the IR lens (12). Brush off any remaining dirt using a
fine lens brush. Wipe the surface of the device with a slightly damp cloth. Only use
water to moisten the cloth. Do not use chemicals or cleaning agents when cleaning.

Replacing the battery

The IR-365 requires an alkaline 9 V compound battery
type 006P, or similar types such as IEC6F22 and
NEDA1604. If the voltage drops below the required
value, the LCD display indicates the symbol for flat
batteries „Low Bat" (23). When this occurs, you should
change the battery.
Proceed as follows to replace the battery:
- Open the battery compartment (5) by folding the out lid
of the battery compartment away from the handle, as
shown in the illustration.
- Replace the battery with a new one of the same type,
and fold the lid of the battery compartment back onto
the handle.
Do not leave any used batteries in the measuring device as even batte-
ries with anti-leakage protection can corrode and thus release chemi-
cals which may be a health hazard or destroy the device.
If the device is not used for longer periods of time, remove the batteries in order to
prevent leaking.
Leaking or damaged batteries may cause alkali burns if in contact with skin. It is
therefore advisable to use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into the
fire.
Batteries must not be recharged. Danger of explosion.
28
Le fonctionnement n'est autorisé que dans les environnements secs, évitez impéra-
tivement tout contact avec l'humidité.
La mesure ne doit pas s'effectuer dans des conditions ambiantes défavorables. Les
conditions ambiantes défavorables sont : poussières et gaz, vapeurs ou solvants
inflammables, orages ou conditions orageuses telles que des champs électrosta-
tiques intenses, etc.
Toute utilisation autre que celle décrite précédemment risque d'en-
dommager ce produit. De plus, elle entraîne des risques de court-
circuit, d'incendie etc. Il est interdit d'ouvrir, de modifier ou de
transformer le produit dans son ensemble !

Contenu de la livraison

Thermomètre infrarouge IR-365RF Emetteur radio Récepteur radio USB Trépied
Adaptateur secteur
Câble de sortie avec fiches de 4 mm pour sortie analogique
Coffret de rangement Pile bloc de 9 V Mode d'emploi
Consignes de sécurité
Tout dommage résultant d'un non-respect du présent mode d'emploi a
pour effet d'annuler la garantie ! Nous déclinons toute responsabilité
pour les dommages consécutifs !
De même, le constructeur décline toute responsabilité en cas de dom-
mages matériels ou corporels résultant d'une utilisation de l'appareil non
conforme aux spécifications ou d'un non-respect des présentes instruc-
tions de sécurité. Dans ces cas, tout droit à la garantie est annulé.
Dans ce mode d'emploi, un point d'exclamation placé dans un triangle
signale les informations importantes. Veuillez lire intégralement le mode
d'emploi avant la mise en service.
Cet appareil est agréé CE et répond ainsi aux directives requises.
Ce signe indique les informations importantes du présent mode d'emploi.
Ce signe indique les avertissements à observer impérativement !
Pour des raisons de sécurité et d'homologation (CE), les transformations et/ou modi-
fications de l'appareil, réalisées à titre individuel, sont interdites.
33

Werbung

Kapitel

loading