VOLTCRAFT IR-1600 CAM Bedienungsanleitung Seite 38

Buzzer
Select the acoustic button confirmation and alarm when the pre-set alarm levels are exceeded.
Options:
Off = no beep
On = beep at push of a button and exceeding of the alarm values
Switching off the screen
Here, you can choose the time after which the screen is to be switched off if no button has been pushed (battery
saving mode).
After switching off, the device may be reactivated by pushing any button. Deactivation is not enabled in
permanent measuring mode.
Options:
Close = Deactivation is disabled
20 seconds = Deactivation takes place after 20 seconds
1 minute = Deactivation takes place after 1 minute
3 minutes = Deactivation takes place after 3 minutes
Switching Off
Here, you can choose the time after which the meter is to be switched off automatically if no button has been
pushed.
After switching off, the device may be reactivated by pushing any button. Deactivation is not enabled in
permanent measuring mode.
Options:
Close = Automatic deactivation is disabled
3 minutes = Deactivation takes place after 3 minutes
15 minute = Deactivation takes place after 15 minute
60 minutes = Deactivation takes place after 60 minutes
Reset default
This resets the device settings to the factory condition. All pre-settings are reset. The saved data are, however,
retained.
Options:
Yes = The device is reset to factory conditions
No = The device is not reset to factory conditions
System update
Here, new firmware can be read in, if present. The update is done via an optional MicroSD card. "SD CARD" must
be chosen as source for the system file in the menu.
38