C) Ir Measurement With Camera Image - VOLTCRAFT IR-1600 CAM Bedienungsanleitung

c) IR Measurement with camera image

The menu item "IR CAM" is used for measurements with activated colour camera. This makes it easier to assign the
measuring point.
Point the measuring opening (13) at the measured object vertically. Observe that the measured object is not smaller
than the IR measuring area of the device.
Push and hold the measuring button (9). In the display, the main measured value and all other enabled parameters
are displayed. The displayed main measured value corresponds to the average surface temperature of the IR
measuring area. During the measurement, the symbol "Start" in the display is concealed and the symbol "Pause" is
shown.
After releasing the measuring button (9), the last measured value is displayed until automatic deactivation (can be
pre-set) for better reading. The symbol "Pause" goes out and the display "Start" appears to indicate readiness for
measurement.
The device will switch off automatically after the pre-set time once the measuring button (9) is released. If this func-
tion has been disabled, always switch off the device manually to avoid discharging the rechargeable battery.
To determine the warmest/coldest points of the measuring object, move the measuring aperture with the
measuring button (9) pushed comprehensively over the surface of the object to be measured. The measured
value is updated at a rate of 150 ms. Additional functions permit automatic display of maximum value "Max"
and minimum value "Min" or average value "Avg" and difference value "Dif". These values are displayed
above and below the main measuring display.
The additional functions "MIN, MAX, DIF, AVG" always refer to the IR measuring function.
Picture and video recording
The IR measurement with camera image also has the advantage that the displayed pictures incl. all measuring
parameters can be recorded as a picture or video file.
To record the picture, push the button "Picture recording" (5). The current picture is recorded.
The two arrows can be used to choose saving the picture (arrow "Up" (5)) or discard the picture (arrow "Down" (3).
After input, the current live picture is displayed again.
To record the video, push the button "Video recording" (3). The symbol "Video recording" is displayed and the
recording is running. To terminate the recording, push the button "Video recording" (3) again. A small floppy disc
symbol in the middle of the image signals that the video file is being saved.
The picture or video file can be viewed in the main menu item "Gallery".
44