Intended Use - VOLTCRAFT IR-1600 CAM Bedienungsanleitung

4. INTENDED USE

The infrared thermometer enables contract-free measurement of surface-temperatures. It determines temperature
according to the radiated infrared energy that is emitted by every object. Contact-free measurement makes it ideal
for dangerous, difficult to access, moving or live objects. It cannot measure through transparent media such as
glass, plastics, water, etc. Instead, the surface temperature is measured at all times. The temperature measuring
range is from -50 to +1600 °C. A double laser target device facilitates determination of the measuring range.
Additionally, a contact measurement with a thermal element sensor type K is possible in the measuring range from
-50 to +1370 °C, depending on the sensor used. This contact sensor must only be used on voltage-free media.
The installed sensors can be used to measure ambient temperature and relative humidity. These measured values
can be used to calculate and display the dew point and the evaporation temperature (wet bulb). There is a mould
warning display.
An integrated colour camera permits recording images and videos with the measured data displayed there. The
data can be recorded in the integrated storage or on an optional micro-SD memory card. A data logger with curve
memory is present.
The IR-thermometer as such must not come directly into contact with the measured contact and surface tem-
perature. A sufficient safety distance and the admissible ambience conditions must be complied with under all
circumstances.
Diagnostic application in the medical area is not admissible.
The degree of emissions can be adjusted to the present surface property of the measured object. A table of common
materials is integrated.
The installed USB interface serves only as a charging interface. Data transmission is not possible.
A 3.7 V Li-Ion battery of type 18500 with a connection plug is used for voltage supply. No energy supply other than
the one indicated must be used. Charging is performed via the integrated USB charging interface.
The enclosed USB plug-in mains adapter is designed in protection class 2 and must only be used in dry inner
rooms.
This product complies with the statutory national and European requirements. For safety and approval reasons
(CE), the entire product must not be changed or converted and the housing must not be opened except for ex-
change of batteries.
Using the product for any other purposes than those described above may damage the product or cause a danger
of injury.
Read the operating instructions precisely and keep them. Only pass the product on to any third parties together with
the operating instructions.
Always observe the safety information included in these operating instructions.
All company names and product names are trademarks of their respective owners. All rights reserved.
31