Inhaltsverzeichnis
Werbung
phyCORE-Z500P(T)
11.5 UMTS (U11)
At position U11, a UC864 UMTS module (and compatible) from
ability for a wide range of communication.
The module is connected to the phyCORE-Z500P(T) via USB port 4 at full speed. There is also a
serial connection via the Super-I/O (U16) at serial2.
For voice function, the analog sound signals are connected to the Analog-Devices HDA sound chip
(U14) and the digital (PCM) signals are connected to the Bluetooth module (U19).
Audio-Signal
Function
EAR_HF+
Hands-free ear output, phase +
MIC_HF+
Hands-free microphone input; phase +
PCM_CLOCK_BT
PCM clock out
PCM_RX_BT
PCM Data input
PCM_TX_BT
PCM Data output
PCM_SYNC_BT
PCM Sync
A SIM-Card must be plugged in at X18 on the bottom side of the phyCORE-Z500P(T) baseboard, to
connect to your service provider. There are several control signals from/to the UMTS module which
are described in the following table.
Signal
UMTS_ON_OFF
UMTS_RESET
UMTS_PWRMON
Led D36 signals the status of the UMTS module/connection. For further information see the Users-
Manual/Datasheet of the mounted module at www.telit.com.
54
Function
direction
Power on/off
Input
Reset
Input
Power Monitor
Output
© PHYTEC Messtechnik GmbH 2009
Telit
can be mounted. This gives the
direction
Connected to
Analog out
Phone_in (U14)
Input
Mono_Out (U14)
Input/Output
SCLK Bluetooth (U19)
Input
SRD Bluetooth (U19)
Output
STD Bluetooth (U19)
Input/Output
SFS Bluetooth (U19)
Connected to
Output of EPLD (U35)
Output of EPLD (U35)
Input of EPLD (U35)
L-732e_0
Werbung
Inhaltsverzeichnis
