Solid State Disk Ssd (U4,U5,U6,U7); Sata-Ii Bridge 88Sa8052 (U19) - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

6.7.1 Solid State Disk SSD (U4,U5,U6,U7)

It is possible to populate 2/4/8/16 GByte SSD on the phyCORE-Z500P(T). Therefore the
ntel® Z-P140 PATA SSD with 2 Gbyte or 4 GByte are used. The following table shows which of the
devices are populated for the different sizes.
2 Gbyte devices (SSDPAPS0002G1)
SSD U4
size
2Gbyte SSDPAPS0002G1
4Gbyte SSDPAPS0002G1
8Gbyte SSDPAPS0002G1
4 Gbyte devices (SSDPAPS0004G1)
SSD U4
size
4Gbyte SSDPAPS0004G1
8Gbyte SSDPAPS0004G1
16Gbyte SSDPAPS0004G1
Caution!
This feature is subject to change. Intel® has discontinued these parts. Phytec will provide a solution
or updated version of the current PCB. It is intended that this new solution will not impact any current
designs.
Please contact our support-/sales-team for further information.

6.7.2 SATA-II Bridge 88SA8052 (U19)

The Marvell SATA-II Bridge 88SA8052 is used to make it possible to expand the available mass
storage memory with standard SATA hard disks.
Signal-Name Description
#SATA_RX SATA receive neg. signal
SATA_RX SATA receive pos. Signal
SATA_TX SATA transmit pos. signal
#SATA_TX SATA transmit neg. signal
© PHYTEC Messtechnik GmbH 2009
U5 U6
--- ---
--- PF29F16G32PANC1
PF29F16G32PANC1 PF29F16G32PANC1
U5 U6
--- ---
--- PF29F32G32PANC1
PF29F32G32PANC1 PF29F32G32PANC1
Nr.
on-board
@ Type
circuit
X2
232
SC 10nF I SATA
234 SC 10nF I SATA
238
SC 10nF O SATA
240
SC 10nF O SATA
L-732e_0
SCH US15WP (T) (U2)
U7
---
---
PF29F16G32PANC1
U7
---
---
PF29F32G32PANC1
Trace length on
Remark
phyCORE
100Ohm diff.,
50 Ohm char.
100Ohm diff.,
50 Ohm char.
100Ohm diff.,
50 Ohm char.
100Ohm diff.,
50 Ohm char.
29