Table 2: Jumper Settings - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

phyCORE-Z500P(T)
The jumpers (J = solder jumper) have the following functions:
Table 2: Jumper Settings
D S
EFAULT ETTING
J1
1 + 2 Selects 3.3 V as I/O-Voltage for
Intel® HDA audio interface.
J2
1 + 2 The Ethernet controller is
powered off during suspend.
J3
open Solid-State-Disk (SSD) is not
write protected.
J4
1 + 2 A SPI-Flash is used as
configuration-/ROM-device for
the Ethernet controller.
18
A S
LTERNATIVE ETTING
1 + 3 Selects 1.5 V as I/O-Voltage
for Intel® HDA audio interface.
1 + 3 The Ethernet controller is
powered on during suspend.
closed Solid-State-Disk is write
protected.
1 + 3 A SPI-EEPROM is used as
configuration-/ROM-device for
the Ethernet controller.
© PHYTEC Messtechnik GmbH 2009
S
EE
S
ECTION
6.11.2
L-732e_0