Jumpers; Figure 4: Numbering Of The Jumper Pads - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

Jumpers

3 Jumpers
For configuration purposes, the phyCORE-Z500PT has 4 solder jumpers, some of which have been
installed prior to delivery. Figure 4 illustrates the numbering of the solder jumper pads, while Figure 5 and
Figure 6 indicate the location of the solder jumpers on the board. Three solder jumpers are located on the
top side of the module (opposite side of connectors). Table 2 below provides a functional summary of the
solder jumpers, their default positions, and possible alternative positions and functions. A detailed
description of each solder jumper can be found in the applicable section listed in the table.
1 2 3
1 2
i.e. J2 i.e. J3
Figure 4: Numbering of the Jumper Pads
© PHYTEC Messtechnik GmbH 2009 15
L-732e_0