The phyCORE-Z500PT offers the following features:
•
Subminiature Single Board Computer (85 x 100 mm) achieved through modern SMD technology
•
Improved interference safety achieved through multi-layer PCB technology and dedicated ground
pins
•
Controller signals and ports extend to one 2 x 120-pin high-density (0.5 mm) Samtec connector
aligned one side of the board, enabling it to be plugged like a "big chip" into target application
•
Populated with the Intel®
437-ball, µFCBGA8 22 x 22 mm)
•
System Controller Hub, US15WP/WPT
•
DDR2 RAM up to 2GB (Kitversion with 512 MB)
•
Solide State Disc (SSD) up to 16GB (Kitversion with 2 GB)
•
Intel® 82574 Ethernet controller with 10/100/1000 Mbit/s
•
8 x USB2.0 (6 x Low-/Full-/High-Speed, 2 x HighSpeed only)
•
microSD slot on board
•
SATA interface (Master / Slave)
•
2 x PCIexpress lanes (On the baseboard an additional PCIexpress switch is populated offering
access to two PCIe x 1, 1 miniPCIe and an Altera Aria-GX FPGA)
•
3 x SDIO port
•
LVDS Display interface (18-/ 24-bit)
•
SDVO Display interface
•
System Management Bus (SMB)
•
Low Pin Count Bus (LPC Bus)
•
5 Volt Single Supply
•
Physical dimensions: 85 x 100 mm
•
Temperature Range:
standard:
0...+70°C
o
extended:
-40...+85°C
o
© PHYTEC Messtechnik GmbH 2009
Atom Z510P/PT, Z520PT or Z530P microprocessor (packaging
L-732e_0
Introduction
3