Inhaltsverzeichnis
Werbung
phyCORE-Z500P(T)
Caution!
Do not use a laboratory adapter to supply power to the baseboard!
Power spikes during power-on could destroy the phyCORE module mounted on the baseboard!
Do not change modules or jumper settings while the baseboard is supplied with power!
Figure 14: Power adapter
The Carrier Board can be powered either with an external Power adapter 5 VDC/3000 mA or an
standard ATX power supply. If an ATX power supply is connected the Power adapter is electronically
disconnected.
A battery (BAT1) is used as backup supply for CMOS and other nonvolatile components on the
module.
Fore ease to see which voltage is powered on/off, there are LED's above the ATX-Power connector.
50
© PHYTEC Messtechnik GmbH 2009
L-732e_0
Werbung
Inhaltsverzeichnis
