Jumpers On The Baseboard Pcm-966; Figure 10: Typical Jumper Numbering Scheme - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

The phyCORE-Z500P(T) on the Carrirer Board

11.2 Jumpers on the Baseboard PCM-966

Carrier Board jumpers allow a variety of signal configurations and connectivity options between the
phyCORE-Z500P(T) module and Carrier Board peripheral connectors. Before making connection to
peripheral connectors it is a good idea to consult the applicable section in this manual for setting the
associated jumpers.
See Table 8 for default settings and descriptions of all Carrier Board jumpers.

Figure 10: Typical jumper numbering scheme

Figure 10 illustrates the numbering scheme for various jumper blocks. Note that in each case pin 1 is
always marked with a clipped corner on the PCB silk screen. Figure 11 highlights the locations of all
user configurable jumpers on the phyCORE-Z500P(T) Carrier Board.
© PHYTEC Messtechnik GmbH 2009 45
L-732e_0