Pin Description (X2) - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

Pin Description

2 Pin Description (X2)

Please note that all module connections are not to exceed their expressed maximum voltage or current.
Maximum signal input values are indicated in the corresponding controller manuals/data sheets. As
damage from improper connections varies according to use and application, it is the user's responsibility to
take appropriate safety measures to ensure that the module connections are protected from overloading
through connected peripherals.
As Table 1 indicates, all controller signals extend to surface mount technology (SMT) connectors (0.5 mm)
on one side of the module (referred to as phyCORE-connector). This allows the phyCORE-Z500P(T) to be
plugged into any target application like a "big chip".
The connector used on the phyCORE-Z500P(T) is a QSH-120-01-L-D-A from Samtec.
QSH-120-01-L-D-A
The mating connector, for the baseboard, is
QTH-120-01-L-D-A
Table 1 provides an overview of the pinout of the phyCORE-connector, as well as descriptions of possible
alternative functions. Table 1 also provides the appropriate signal level interface voltages listed in the SL
(Signal Level) column. The Intel® Z500PT is a multi-voltage operated microcontroller and as such special
attention should be paid to the interface voltage levels to avoid unintentional damage to the microcontroller
and other on-board components. Please refer to the Intel® Z500PT User's Manual/Data Sheet for details
on the functions and features of controller signals and port pins.
© PHYTEC Messtechnik GmbH 2009 7
L-732e_0