Module Connector (X1); Power Supply (X37) / Atx-Power; Figure 13: Power Supply (X37) - Phytec phyCORE-Z500PT Hardware Bedienungsanleitung

11.3.1

Module Connector (X1)

The phyCORE-Z500P(T) must be placed correctly onto the Carrier Board at X1. Be careful when
pushing down the module. It is possible to bolt the module at the baseboard with 8 mm bolts.
11.3.2

Power Supply (X37) / ATX-Power

X37
ATX

Figure 13: Power Supply (X37)

© PHYTEC Messtechnik GmbH 2009
The phyCORE-Z500P(T) on the Carrirer Board
ATX-Power
L-732e_0
49