Open Window Function / Airing ( , Aer); Setting The Offset Temperature (Tof) - eQ-3 EasyHome control Bedienungsanleitung

• Confirm the setting with the OK button.
While the "de-scaling run" is performed the display will
show "CAL".
17.8 Open window function / airing ( , AEr)
During the airing of a room the wall thermostat will auto-
matically reduce the room temperature to save heating
costs. Meanwhile, in this phase the display of the wall
thermostat and all taught-in devices will show the open
window symbol ( ).
Combined with a Window Sensor the opening and closing
of a window will be detected time-accurate. The tempera-
ture will only be reduced to the factory setting of 12° C while
the window is opened. Once the Window Sensor registers
the closing of the window, all components installed in the
room will be reset to the previous mode.
To change the reduced temperature setting proceed as
follows:
• Press the Mode button for more than 3 seconds.
• Select the "AEr" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• Set the temperature with the (+) and (-) buttons.
• Confirm the setting with the OK button.

17.9 Setting the offset temperature (tOF)

As the temperature is measured on the room control unit the
temperature distribution can vary throughout a room. To
adjust this, a temperature offset of ±3.5°C can be set. If a
nominal temperature of e.g. 20°C is set at the room con-
49