Teach-Out / Reset (Res); Information About Radio Operation - eQ-3 EasyHome control Bedienungsanleitung

trol unit but the room presents with only 18°C an offset of
-2.0°C needs to be set.
• Press the Menu button for more than 3 seconds.
• Select the "tOF" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• Set the offset temperature with the (+) and (-) buttons.
• Confirm the setting with the OK button.
The wall thermostat can be reset to the initial state ma-
nually. Restoring the initial state deletes all settings and
information about taught-in devices.
Before you reset the wall thermostat to the factory
settings, first delete the device from the software
when operating with the Cube..
• Press the Menu button for more than 3 seconds.
• Select the "rES" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• The display will show "ACC", confirm restored factory
settings with the OK button.
If a room control unit is taught-in to the LAN Gateway
the configuration menu on the device will be locked.
You can still restore the factory settings:
• Remove a battery and wait for 60 seconds.
• Press and hold down reduce ( ), OK and the - button
simultaneously and insert the battery at the same time
• Release the button. You can now start to make the setting.
50

18. Teach-out / Reset (rES)